Wheel Bearing Housing: Installing

-- Install wheel bearing housing on driveshaft.

-- Bolt transverse link to wheel bearing housing; use new self-locking nut (arrow); torque to 200 Nm (148 ft lb).

-- On rear axle with stabilizer bar, mount stabilizer bar link rod bracket.

-- Connect lower strut, install new self-locking nuts, and tighten bolts to 90 Nm (66 ft lb), only with vehicle resting on wheels.

-- Fasten wheel bearing housing onto support and trapezoidal arm. Use new self-locking mounting bolts. Tighten bolts to 170 Nm (104 ft lb) plus another 3/4-turn (225°), with vehicle resting on wheels.

-- Press ABS wheel speed sensor in to stop.

-- Install brake disc and caliper; tighten to 65 Nm (48 ft lb).

-- Install wheel.

-- Install new bolt and washer assembly and tighten to 200 Nm (148 ft lb) plus another 1/4-turn (90°), only with vehicle resting on wheels.

-- Install hub cap and/or wheel cover.