Overview - Seat Position Sensor
WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.
- Wiring Harness
- Seat position sensor/passenger occupant detection sensor/seat belt switch
- Clipped in the seat pan
- Black connector, connector station in the vehicle floor under the seat
- Removing and Installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Passenger Seat Occupant Detection Sensor -G128-
- Only the front passenger side
- Removing and Installing. Refer to Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING .
- Push into the seat pan until they click into place
- Connector Coupling
- For the Seat Belt Latch
- Seat Rail
- Tunnel-side
- Seat Position Sensor
- Driver Seat Position Sensor -G553-
- Front Passenger Seat Position Sensor -G554-
- Shown on the front passenger side
- Removing, installing and adjusting. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING
- Checking. Refer to Vehicle Diagnostic Tester.
- Bolt
- 1.6 Nm