Outer Rear Three-Point Seat Belt, Removing And Installing, Sedan: Installing
WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.
- If parts of the seat belt system are removed due to an accident, replace the belt system bolts.
- Make sure the connectors are pushed in all the way and that they engage audibly.
- Equipped on some models: after replacing the Left Rear Seat Belt Tensioner Control Module -J1097- /Right Rear Seat Belt Tensioner Control Module -J1098-, the control module must be adapted using the Vehicle Diagnostic Tester.
-- Insert the three-point seat belt -1- with the anti-twist mechanism and bolt -2- into the mount -3-.
-- Push the three-point seat belt all the way forward -arrow- and tighten the bolt at the same time.
Further installation is the reverse order of removal.