Center Rear Three Point Seat Belt In Rear Shelf, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the front seats all the way forward.

-- Remove the fixed backrest. Refer to REAR SEAT BACKREST, REMOVING AND INSTALLING .

-- Remove the rear belt end fitting in the center. Refer to REAR SEAT BELT LATCH, REMOVING AND INSTALLING .

-- Remove the D-pillar trim panels. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING, SEDAN .

-- Remove the C-pillar trim panels. Refer to C-PILLAR-TRIM PANEL, REMOVING AND INSTALLING, SEDAN .

-- Remove the rear shelf. Refer to REAR SHELF, REMOVING AND INSTALLING .

-- Loosen the bolt -1- (luggage compartment side) approximately seven turns.

Courtesy of AUDI OF AMERICA, LLC

-- Push the rear shelf noise insulation to the side in the area of the seat belt.

-- Push the three-point seat belt -2- toward the rear out of the mount and remove upward -arrow-.