Seat Occupant Detection Sensors -G177-, -G178- And -G1010-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the bench seat. Refer to REAR BENCH SEAT, REMOVING AND INSTALLING .

-- Place the bench seat on a clean surface.

Outer passenger occupant detection sensor:

Courtesy of AUDI OF AMERICA, LLC

-- Free up and disconnect the connector -arrow A- for the passenger occupant detection sensor.

-- Unclip the passenger occupant detection sensor -1- from the seat frame -arrow B- and remove.

Center passenger occupant detection sensor:

-- Remove the bench seat cover and cushion. Refer to OVERVIEW - COVER AND CUSHION .

-- Disconnect the bench seat cover and cushion. Refer to OVERVIEW - COVER AND CUSHION .

-- Disconnect the connector for the passenger occupant detection system pressure sensor.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the passenger occupant detection sensor -1- on the adhesive surfaces -arrows- carefully from the cushion and remove.