Pressure Hose Sensor for Front Pedestrian Protection -G579-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.
-- Engage the pedestrian protection crash sensor -1- into the molded foam part -3-.
CAUTION:
Risk of damaging the pressure hose due to improper handling.
- Do not kink or turn the pressure hose.
- The pressure hose -2- must be inserted without any tension.
-- Install the molded foam part with the pedestrian protection crash sensor. Refer to MOLDED FOAM PART, REMOVING AND INSTALLING .
Further installation is performed in reverse order of removal, while noting the following:
CAUTION:
Pyrotechnical components can deploy unintentionally.
There is a risk of injury.
- Discharge static electricity by briefly touching the door striker.
-- Attach the connector -1- to the crash sensor until it clicks into place in direction of -arrow-.
-- Push in the connector lock -2- to secure the connector.
- Make sure the wires are not pinched.
- If the instrument cluster indicates a fault in the airbag system after assembly, the DTC memory must be checked, erased, and then checked again. Refer to Vehicle Diagnostic Tester.