Pedestrian Protection Trigger 1 -G598- /Pedestrian Protection Trigger 2 -G599-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

CAUTION:

Pyrotechnical components can deploy unintentionally.

There is a risk of injury.

- Discharge static electricity by briefly touching the door striker.

Make sure the connectors are pushed in all the way and that they engage audibly.
Make sure the wires are not pinched.
If the instrument cluster indicates a fault in the airbag system after assembly, the DTC memory must be checked, erased, and then checked again. Refer to Vehicle Diagnostic Tester.