Overview - Pedestrian Protection
WARNING: This page is about a different car, the 2022 Audi RS 6 Avant and 2021 Audi RS 6 Avant. However, it is still accessible from the selected car via links, so may be relevant.
- Pressure Hose Sensor for Front Pedestrian Protection -G579-
- LHD in the direction of travel on the left side: Driver Side Pedestrian Protection Crash Sensor 2 -G851-
- LHD in the direction of travel on the right side: Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
- RHD in the direction of travel on the right side: Driver Side Pedestrian Protection Crash Sensor 2 -G851-
- RHD in the direction of travel on the left side: Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
- Component location: in the molded foam part on the impact member
- Must be replaced when
- The molded foam part is visibly damaged.
- The impact member is visibly deformed.
- Bumper cover very damaged / visibly damaged
- The pressure hose is damaged.
- Place the pressure hose in the groove on the molded foam part.
- Insert the pressure hose in the center of the molded foam part, the projecting end is the same on both the left and right side.
- Do not kink or squeeze the pressure hose.
- Removing and Installing. Refer to Pressure Hose Sensor for Front Pedestrian Protection -G579-, REMOVING AND INSTALLING .
- Pedestrian Protection Crash Sensor in Direction of Travel on the Right Side
- LHD: Front Passenger Side Pedestrian Protection Crash Sensor -G571-
- RHD: Driver Side Pedestrian Protection Crash Sensor -G570-
- On the bumper cover
- Removing and Installing. Refer to PEDESTRIAN PROTECTION CRASH SENSOR -G570- / -G571-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Pedestrian Protection Center Crash Sensor -G693-
- On the lock carrier cover
- Removing and Installing. Refer to Pedestrian Protection Center Crash Sensor -G693-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Bolt
- 4 Nm
- Seal
- Pedestrian Protection Trigger in Direction of Travel on the Right Side
- LHD: Pedestrian Protection Trigger 2 -G599-
- RHD: Pedestrian Protection Trigger 1 -G598-
- Triggered Pedestrian Protection, Resetting. Refer to HINGE, RESETTING
- Removing and Installing. Refer to Pedestrian Protection Trigger 1 -G598- /Pedestrian Protection Trigger 2 -G599-, REMOVING AND INSTALLING .
- Seal
- Clip
- Clip
- Seal
- Pedestrian Protection Trigger in Direction of Travel on the Left Side
- LHD: Pedestrian Protection Trigger 1 -G598-
- RHD: Pedestrian Protection Trigger 2 -G599-
- Triggered Pedestrian Protection, Resetting. Refer to HINGE, RESETTING
- Removing and Installing. Refer to Pedestrian Protection Trigger 1 -G598- /Pedestrian Protection Trigger 2 -G599-, REMOVING AND INSTALLING .
- Seal
- Bolt
- 4 Nm
- Bolt
- 9 Nm
- Pedestrian Protection Crash Sensor in Direction of Travel on the Left Side
- LHD: Driver Side Pedestrian Protection Crash Sensor -G570-
- RHD: Front Passenger Side Pedestrian Protection Crash Sensor -G571-
- On the bumper cover
- Removing and Installing. Refer to PEDESTRIAN PROTECTION CRASH SENSOR -G570- / -G571-, REMOVING AND INSTALLING .