Front Passenger Airbag Unit With Igniter, Removing And Installing: Installing
Install in reverse order of removal and note the following:
- Replace the connector for the Front Passenger Airbag Release Valve Igniter -N491- after an airbag has deployed. Refer to WIRING HARNESS AND CONNECTOR REPAIRS .
Pyrotechnical components can deploy unintentionally.
There is a risk of injury.
- Discharge static electricity by briefly touching the door striker.
-- Connect the connector -1- to the airbag igniter -arrow A-.
-- Press in the connector lock -2- -arrow B-. While doing this, the connector is pushed into the airbag igniter all the way and locks into place.
- Make sure the wires are not pinched.
-- If battery was disconnected, follow all steps required for reconnecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .
Risk of airbag deployment.
There is a risk of injury.
- Switching on the ignition (key/button) after assembly may only be done when the driver seat is positioned all the way back.
- If the instrument cluster indicates a fault in the airbag system after assembly, the DTC memory must be checked, erased, and then checked again. Refer to Vehicle Diagnostic Tester.
Information for installation: for example, tightening specifications, replacing body parts. Refer to OVERVIEW - FRONT PASSENGER AIRBAG and OVERVIEW - INSTRUMENT PANEL .