A5 / S5 - Technician Reference Document
WARNING: This page is about a different car, the 2020 Audi S5 and 2020 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Vehicle Preparation
| □ | → Perform any open campaigns Follow instructions listed in campaign documentation |
| □ | → Perform diagnostic work Connect Vehicle Diagnostic Tester - Select "Diagnosis" mode and start diagnosis - Perform vehicle identification - Deselect "Working with Guided Fault Finding - Switch to "Special functions" tab and select following program: ■ Delivery Inspection Total ■ - Start program by selecting "Carry out check" - Continue to follow instructions on screen and complete the process - Switch to the "Control units" tab, press the "Guided Fault Finding" button and launch Guided Fault Finding as far as the test plan - The static event memory entries must be evaluated and, if necessary, processed using Guided Fault Finding - Exit diagnosis; diagnostic log for delivery inspection is sent automatically |
Exterior
| □ | → Check all key buttons and features Check functionality of all keys. Verify vehicle starts and runs with all keys and the start / stop button. Verify all doors and trunk remotely lock / unlock with all keys, including all door handle sensors with Advanced Key (if equipped) |
Lighting and Windshield
| □ | → Test windshield washers. Correct aim if necessary Headlights must be on to test functionality of the headlight washers |
Trunk Inspection
| □ | → Install wheel bolt cover removal tool from PDI kit into trunk tool kit Install wheel bolt cover removal tool from PDI kit and wheel lock key (if applicable) into trunk tool kit |
| □ | → Set spare tire pressure See separate "Audi Normal Load Condition Tire Pressure Table" posted on ServiceNet |
| □ | → Check battery clamps for proper torque Refer to Elsa Pro for specification |
Interior
| □ | → Check operation of window, lock, and seat controls Check operation of all switches: Locks, windows, seat adjustment, heated seats (if equipped) and child safety features |
| □ | → Inspect mirrors for proper operation Inspect folding, adjustments, right side tilt in reverse, heating (if equipped) |
| □ | → Check rear view mirror operation Check self-dimming function / lighting (if equipped) |
| □ | → Verify proper operation of climate control Ensure proper heating and A / C cooling and open all panel vents |
| □ | → Inspect operation of all power outlets Inspect operation of front outlet, aux. outlet under armrest, and rear outlets |
| □ | → Check panoramic sunroof and sunshade operation Verify open / close / vent / deflector at edge and sunshade operation |
Settings
| □ | → Set Time source setting to "GPS" and set Auto daylight savings time to "on." Change time zone appropriate to the dealer location |
| □ | → Verify and set language and measurement units This can be changed in the Setup / Settings menu |
| □ | → Verify Speech Dialog System is operating Press the "Talk" button and verify several commands |
| □ | → Set "Entertain. Fad." in Parking aid to an audible level Via Menu > Vehicle > Driver Assistance > Parking Aid |
| □ | → Set "Music volume while parking" to medium Accessed via MMI rear view camera display, Settings > Music volume while parking (applies to vehicles with park assist or rear view camera) |
| □ | → Set dealership location in navigation (if equipped) Set dealership location for following back to dealership during road test |
| □ | → Turn off Manual Speed Warning (if equipped) This can be changed in the Driver Assistance settings by going to Menu > Vehicle > Driver Assistance > Speed Warning > Manual->Select Off |
Media / Radio / SAT
| □ | → Verify HD RadioTM is turned "off" This can be found in the Radio / Settings Menu |
Audi connect® (USA ONLY) (if equipped)
| □ | → Turn on the Wi-Fi® hotspot (if equipped) Ensure the wireless network is turned on (Telephone > Right Option > Wi-Fi® options > Wi-Fi® "On") |
| □ | → Check Wi-Fi® hotspot visibility. No data available at PDI (if equipped) Check Wi-Fi® hotspot functionality is enabled and verify the SSID is set to "AUDIXXXXX", where XXXXX = the last five digits of VIN that are automatically preset in the system |
| □ | → Enable Google Earth view for navigation (if equipped) Enable Google Earth view in the Navigation > Map Settings and verify the white Google logo appears in the bottom right-hand corner of the MMI screen next to the LTE symbol. |
On-Hoist Inspection
| □ | → Install wheel bolt covers and center caps as supplied Wheel bolt covers and center caps can be found in the PDI kit |
| □ | → Inspect wheel bolts for proper torque Use torque wrench to verify |
| □ | → Set and store tire pressures for either sold vehicle OR stock inventory vehicle If a known "sold" unit, set to appropriate Normal Load Condition. See separate "Audi Normal Load Condition Tire Pressure Table" posted on ServiceNet. If going to stock, set to maximum recommended tire pressures listed on the B-pillar door jamb, and store tire pressure values in Car / System menu |
Driving Performance
| □ | → Verify engine Start-Stop System functionality Verify the velum sticker is on the start / stop button. Remove the start / stop information card from the car kit and place it in the glove box with the owners manuals. Additional supply can be ordered via the Brand Store on AccessAudi |
| □ | → Verify engine performance and acceleration Listen for abnormal noise / vibrations |
| □ | → Test drive vehicle applying brakes several times Apply brakes at least 4 times at 20 m.p.h. (35 km / h) to clean brake rotors. Check for abnormal noise / vibration / pulsation |
| □ | → Calibrate rear view mirror Calibrate rear view mirror compass to proper zone and check self-dimming function / lighting (if equipped) |
Driver Assistance
| □ | → Verify operation of parking system (if equipped) Verify operation of Audi parking system sensors with rear view camera (if equipped) |
| □ | → Verify all vehicle Head-up display functionality (if equipped) Verify the image can be adjusted properly in the viewing area of the windshield. Verify not available directions, speed, cruise control, and lane assist are all visible in Head-Up Display (as equipped) |
Convertible Functionality (if equipped)
| □ | → Test operation of power folding top Perform with engine running to conserve battery power |
Post-Road Test Inspection
| □ | → Check engine oil level Fill oil to the max level when the vehicle is at operating temperature |