Intake Manifold, Removing And Installing, 3.0L Engine, AUDI A4/A5/A6/A7/Q5

Special tools and workshop equipment required

NOTE:

The crankcase ventilation hose cannot be separated from the intake manifold. Note the information -item 11.

Removing

-- Pay attention to the repair information. Refer to REPAIR INFORMATION .

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the lock carrier cover. Refer to Front Bumper .

Audi A4/A5:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the air guide -2-.

Audi A6/A7:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the air duct.

Audi Q5:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and air duct -1-.

All:

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamp -2- and remove the air duct pipe.

-- Free up the wiring harness -3-.

-- Remove the bolts -arrows-.

-- Remove the intake manifold and crankcase ventilation hose -1- by pressing the release buttons on both sides.

-- If installed, remove the hose -1- for the EVAP system by pushing the release buttons on both sides.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the crankcase ventilation hose -arrows- by pressing the release buttons on both sides.

-- Remove the intake manifold.

Installing

Install in reverse order of removal and note the following:

Tightening Specifications