Instrument Cluster: Notes

General notes

Before removing instrument cluster, note vehicle mileage
After replacing the instrument cluster, the vehicle mileage and all SRI indicators are to be re-established/coded into the new cluster.
Note the Airbag safety information, where applicable.
Functional tests of the instruments should be conducted.
See applicable wiring diagram for routing of terminals and checking multi-pin connectors.

Test requirements

Fuses OK, check according to wiring diagram.
Always check the coding of the instrument cluster with scan tool: VAG1551 .

NOTE:

"Automatic Test Sequence" function 10 is not possible with scan tool: VAG1551 with software status 4.0 (version 4.0 card). The control modules should be checked individually using their respective address words. With the update of test software this function will be possible.