Instrument Cluster Mileage Display, Setting
Special tools and workshop equipment required
- Fault Read Out Device: VAG1551
- This setting is only possible with a new cluster
- This setting is possible only one time for each instrument cluster.
- Only a larger setting value can be entered.
- If the wrong information has been entered and confirmed; correction is not possible. The instrument cluster must be replaced.
Setting of service interval display must be done in kilometers. Therefore calculate the value from miles to km. Multiply miles by 1.6 to convert to km.
-- Press buttons 1 and 1 "Login-Procedure" function 11.
Indicated on display
| Rapid data transfer Q 11 - Login-Procedure |
-- Press Q button to confirm input.
Indicated on display
| Login-Procedure Enter code number XXXXX |
-- Input code number 13861.
-- Press Q button to confirm input.
Indicated on display
| Rapid data transfer HELP Select function XXXXX |
-- Press buttons 1 and 0 to select "Adaptation" function 10.
Indicated on display
| Rapid data transfer Q 10 - Adaptation |
-- Press Q button to confirm input.
Indicated on display
| Channel number entered XX |
-- Press button 0 and 9 to select channel 9.
-- Press Q button to confirm input.
Indicated on display
| Channel 9 Adaptation 2 → ← 1 3 → |
-- Advance through program sequence with → button.
Indicated on display
| Channel 9 Adaptation 2 Q XXXXX |
-- Enter adaptation value.
Example:
Kilometer status = 89627; adaptation value = 08963
-- Round ones value up to the next tens and drop ones place (627 becomes 630; drop zero).
-- Add zero in hundred-thousands place.
Ones: round to the next tens
| X | Hundred thousands: 100000 - 900000 km | ||||
| X | Ten thousands: 10000 - 90000 km | ||||
| X | Thousands: 1000 - 9000 km | ||||
| X | Hundreds: 100 - 900 km | ||||
| X | Tens: 10 - 90 km |
-- Press Q button to confirm input.
Indicated on display
| Channel 9 Adaptation 2 Q ← 1 3 → |
-- Press Q button to confirm input.
Indicated on display
| Channel 9 Adaptation 2 Q Store revised value? |
-- Press Q button to confirm input.
Indicated on display
| Channel 9 Adaptation 2 Changed values stored |
-- Press → button to end coding.
Indicated on display
| Rapid data transfer HELP Select function XX |
-- Press button 0 and 6 "End Output" function 06.
Indicated on display
| Rapid Data Transfer Q 06 - End Output |
-- Press Q button to confirm input.