Instrument Cluster Assembly
NOTE:
Removing and installing INSTRUMENT CLUSTER
Use the following tools when performing electrical checks on the instrument cluster:
- Digital multimeter (Fluke 83 or equivalent)
- Instrument/Gauge Tester: Vag1301
- Test Box: Vag1598A
- Adapter: Vag1598/4 Harness
- : Vag1598/13 Adapter Harness
- Front frame with glass
- Removing and installing FRONT FRAME WITH GLASS
- Symbol plate
- Warning light housing
- Speedometer
- Speedometer Vehicle Speed Sensor (VSS)
- Removing and installing SPEEDOMETER
- Analog clock
- Removing and installing ANALOG CLOCK
- Oil temperature gauge
- Checking OIL TEMPERATURE AND OIL PRESSURE GAUGES, CHECKING
- Removing and installing OIL TEMPERATURE GAUGE
- Oil pressure gauge
- Checking OIL TEMPERATURE AND OIL PRESSURE GAUGES, CHECKING
- Removing and installing OIL PRESSURE GAUGE
- Instrument support (side panel)
- Warning light housing (side panel)
- Removing and installing WARNING LIGHT HOUSING, SIDE PANEL
- Printed circuit (side panel)
- Removing and installing PRINTED CIRCUIT, SIDE PANEL
- Cover (side panel)
- Warning buzzer -H3-
- Installation position INSTRUMENT CLUSTER
- Warning buzzer bracket
- Gear selector display
- Removing and installing GEAR SELECTOR DISPLAY
- Fuel gauge
- Checking VOLTAGE STABILIZER AND FUEL GAUGE, CHECKING
- Removing and installing FUEL GAUGE
- Multi-point connector, red (instrument panel wiring harness)
- Terminal identification INSTRUMENT CLUSTER CONNECTORS, TERMINAL IDENTIFICATION
- Removing, installing and repairing connector INSTRUMENT CLUSTER CONNECTORS
- Six-point connector for printed circuit (side panel)
- Terminal identification INSTRUMENT CLUSTER CONNECTORS, TERMINAL IDENTIFICATION
- Voltage stabilizer with heat sink
- Trip computer potentiometer (range calibration)
- Outside temperature display with 5-point connector
- Removing and installing OUTSIDE TEMPERATURE DISPLAY
- Cover
- Removing and installing COVER
- Printed circuit for Auto-Check system and trip computer
- With fuel economy correction switch and country code switch
- Coding connector (plug) for trip computer
- Instrument panel light dimmer switch
- Removing and installing INSTRUMENT PANEL LIGHT DIMMER SWITCH
- Multi-point connector, green (instrument panel wiring harness)
- Terminal identification INSTRUMENT CLUSTER CONNECTORS, TERMINAL IDENTIFICATION
- Removing, installing and repairing connector INSTRUMENT CLUSTER CONNECTORS
- Printed circuit
- Removing and installing PRINTED CIRCUIT
- Instrument support
- Auto-Check system/trip computer display unit
- Removing and installing TRIP COMPUTER AND/OR AUTO-CHECK SYSTEM DISPLAY
- Adjusting knob for instrument panel light dimmer switch/ button for Auto-Check system test
- Coolant temperature gauge
- Checking COOLANT TEMPERATURE GAUGE AND WARNING, CHECKING
- Removing and installing COOLANT TEMPERATURE GAUGE
- Tachometer
- Removing and installing TACHOMETER