LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2021 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 517 (Crankshaft, Cylinder Block (8-Cylinder Direct Injection 4.0L 4V TFSI Engine Ea825)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt, Removing And Installing >> Starter Generator Ribbed Belt, Removing And Installing >> Installing

Starter Generator Ribbed Belt, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2023 Audi SQ8, 2023 Audi RS Q8, 2022 Audi SQ8, 2022 Audi RS Q8, and 2021 Audi SQ8. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Position the ribbed belt. Refer to OVERVIEW - CYLINDER BLOCK, BELT PULLEY SIDE .

-- To tension the ribbed belt release the tensioner.

-- Check whether the ribbed belt is routed correctly.

-- Install the A/C compressor ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Start the engine and check the ribbed belt routing.

scientia non olet · About LEMON Manuals