Overview - Oil Pan/Oil Pump
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2023 Audi SQ8, 2023 Audi RS Q8, 2022 Audi SQ8, 2022 Audi RS Q8, and 2021 Audi SQ8. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Replace after removing
- Tightening Specifications and Sequence. Refer to Fig 2.
- Oil Pan Lower Section
- Removing and Installing. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
- Intake Tube
- For the oil pump
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Chain Guard
- Chain Sprocket
- For the oil pump
- Bolt
- Replace after removing
- 20 Nm +90°
- Seal
- Replace after removing
- Bolt
- Replace after removing
- Tightening Specifications and Sequence. Refer to Fig 3.
- Oil Pan Upper Section
- Removing and Installing. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Alignment Pin
- In cylinder block
- Bolt
- 9 Nm
- Oil Tray
- Alignment Pin
- In cylinder block
- Alignment Sleeve
- Oil Pump
- Removing and Installing. Refer to OIL PUMP, REMOVING AND INSTALLING .
- Do not disassemble
- Bolt
- 9 Nm
- O-Ring
- Replace after removing
- Bolt
- 9 Nm
- Seal
- Replace after removing
- Fluid Drain Plug
- Oil the threads
- 30 Nm
- Bolt
- 9 Nm
- Oil Level Thermal Sensor -G266-
- Removing and Installing. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- Seal
- Replace after removing
Oil Pan Lower Section - Tightening Specifications and Sequence
-- Tighten the bolts -1 to 18- as shown in steps.
| Step | Tightening Specification/Additional Turn |
|---|---|
| 1. | Install all the way by hand |
| 2. | 9 Nm |
Oil Pan Upper Section - Tightening Specifications and Sequence
- These multiple tightenings to 9 Nm take into account the shrinkage of the components.
-- Tighten the bolts -1 to 21- in steps as shown:
| Step | Tightening Specification |
|---|---|
| 1. | Install all the way by hand |
| 2. | 9 Nm |
| 3. | 9 Nm |