Camshaft Timing Chain, Removing From Camshafts, Cylinder Bank 1 (Right): Notes

WARNING: This page is about a different car, the 2024 Audi SQ5 and 2023 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

For the following procedure the camshaft timing chain remains on the engine.

Special tools and workshop equipment required

Electronic Torque Wrench 3-60Nm:VAS6583

Fig 1: Electronic Torque Wrench 3-60Nm
Courtesy of AUDI OF AMERICA, LLC
Locking Pins:T03006

Fig 2: Locking Pins
Courtesy of AUDI OF AMERICA, LLC
Crankshaft Locking Pin:T40069 (with the engine removed)

Fig 3: Crankshaft Locking Pin T40069
Courtesy of AUDI OF AMERICA, LLC
Wrench - 21mm:T40263

Fig 4: Identifying Wrench - 21mm
Courtesy of AUDI OF AMERICA, LLC
Camshaft Lock:T40264/3

Fig 5: Camshaft Lock
Courtesy of AUDI OF AMERICA, LLC
Adapter:T40314

Fig 6: Adapter T40314
Courtesy of AUDI OF AMERICA, LLC
Camshaft Positioning Tool:T40331 , not illustrated
Socket :T90000 , not illustrated
Counterholder:T90001 , not illustrated
Counterholder:T90002 , not illustrated
Torque Wrench Insert - Ring Tool Attachment AF41:VAS261001 , not illustrated
Hazet 6423C (commercially available), not illustrated or Torque Wrench Adaptor:7370/10

Camshaft Locking Device:T40331 , Preparing

Courtesy of AUDI OF AMERICA, LLC

The lettering "A" on the Camshaft Positioning Tool:T40331/1 points forward.
The Camshaft Positioning Tool:T40331/4 and :T40331/5 as well as the washers on the Bolts :T40331/9 must be positioned using the alignment pins -arrows-.

-- Tighten the bolts hand-tight.