Part II
WARNING: This page is about a different car, the 2020 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Part I. Refer to Part I .
- Support
- Turbocharger
- Removing and installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING .
- O-Ring
- Always replace after removing.
- Coat with engine oil
- Line
- For the crankcase ventilation
- Do not separate versions with threaded connections -item 5- Part II => List Item:Bolt/Threaded Connection from the turbocharger
- Bolt/Threaded Connection
- 9 Nm
- Depending on the version a bolt or a threaded connection with a connected hose is installed.
- Do not separate the threaded connection from the turbocharger
- Oxygen Sensor 1 Before Catalytic Converter -GX10-
- Removing and Installing. Refer to HEATED OXYGEN SENSOR, REMOVING AND INSTALLING .
- O-Ring
- Always replace after removing.
- Coat with engine oil
- Oil Supply Line
- Bolt
- 9 Nm
- O-Ring
- Always replace after removing.
- Coat with engine oil
- Bolt
- 9 Nm
- Bolt
- 30 Nm
- Coat the with hot bolt paste.
- Heat Shield
- Bolt
- 9 Nm
- Coolant Supply Line
- O-Ring
- Always replace after removing.
- Coat with engine oil
- Bolt
- 9 Nm
- O-Ring
- Always replace after removing.
- Coat with coolant
- Bolt
- 20 Nm + 90°
- Always replace after removing.