Oil Spray Jets, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2023 Audi SQ8, 2023 Audi RS Q8, 2022 Audi SQ8, 2022 Audi RS Q8, and 2021 Audi SQ8. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Remove the bolts -arrows- and remove the oil tray -1-.

Courtesy of AUDI

Courtesy of AUDI

CAUTION:

Risk of damaging the engine by the timing mechanism skipping.

- Only let the engine turn in the direction of engine rotation.

-- Turn the crankshaft using the Wrench - 21mm:T40263 and Adapter:T40314 -arrow- until the corresponding oil spray jet is accessible.

-- Mark the installation position and the connecting rod bearing cap allocation to the cylinder and connecting rod for installing again later. Refer to Figure.

Fig 1: Connecting Rod Bearing Cap

Courtesy of AUDI

-- Remove the corresponding bolts -arrows- and remove the connecting rod bearing cap.

-- Remove the banjo bolt -2- and the oil spray jet -1-.

Courtesy of AUDI

-- Repeat the procedure if necessary on each oil spray jet.