OVERVIEW - CYLINDER BLOCK BELT PULLEY SIDE, BELT DRIVE Generator -C-
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2023 Audi SQ8, 2023 Audi RS Q8, 2022 Audi SQ8, 2022 Audi RS Q8, and 2021 Audi SQ8. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 30 Nm
- Tensioner
- For the ribbed belt
- Removing and Installing. Refer to RIBBED BELT TENSIONER FOR Generator -C-, REMOVING AND INSTALLING .
- Bolt
- Quantity: 2
- Tightening specifications. Refer to OVERVIEW - GENERATOR .
- Generator -C-
- Removing and installing. Refer to GENERATOR, REMOVING AND INSTALLING .
- Bolt
- Quantity: 4
- 20 Nm
- Bracket
- For the Generator -C-
- Removing and Installing. Refer to Generator -C- BRACKET, REMOVING AND INSTALLING .
- Alignment Sleeve
- Alignment Pin
- Vibration Damper
- with friction disc (diamond disc) for the connection security between the vibration damper and the crankshaft stub (cannot be delivered separately)
- There are different versions. Refer to the appropriate Electronic Parts Information for the allocation.
- Removing and Installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tightening Specifications
- Pre-tightening 50 Nm
- Final tightening specification 100 Nm +180°
- Ribbed Belt
- Check for wear
- Do not kink
- Belt path. Refer to Fig 2.
- Before removing, mark the running direction using chalk or a felt-tip pen.
- Removing and Installing. Refer to Generator -C- RIBBED BELT, REMOVING AND INSTALLING .
- When installing, make sure it is seated correctly on the belt pulleys
- Bolt
- 30 Nm
Belt path for GeneratorC
- Generator
- Vibration Damper
- Tensioner