Exhaust System, Installing Without Tension

Procedure

• Align the exhaust system when cold.

-- Loosen the front clamping sleeve(s) -arrows-.

Fig 1: Identifying Bolts

Courtesy of AUDI

All except Audi A8/Q7/Q8:

Courtesy of AUDI

-- Push the exhaust system far enough forward -arrow- until the pretension on the retaining loop -1- at the exhaust pipe is -a- = 6 to 10 mm.

-- Position the front clamping sleeve (refer to the appropriate Service Information. ) and tighten the threaded connections evenly.

Audi A8/Q7/Q8:

Courtesy of AUDI

-- Push the exhaust system far enough forward -arrow- until the pretension on the retaining loop at the exhaust pipe is -a- = 6 to 10 mm.

-- Position the front clamping sleeves (refer to the appropriate Service Information. ) and tighten the threaded connections evenly.

Tightening Specifications

• Refer to OVERVIEW - MUFFLER