Oil Pan Lower Section, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ5 and 2023 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Engine oil drained. Refer to ENGINE OIL .

-- If installed, remove the bolt -1- and push the bracket -2- with the wiring harness to the side.

Fig 1: Identifying Wiring Harness Bracket

Courtesy of AUDI

-- Disconnect the connector -arrow- from the Oil Level Thermal Sensor -G266-.

Fig 2: Oil Pan Lower Section - Tightening Sequence

Courtesy of AUDI

-- Free up the wires.

-- Loosen and remove the bolts in the following sequence: -17 to 1-.

-- Loosen and remove the oil pan lower section carefully from the bonding.