Charge Air System, Checking For Leaks
Special tools and workshop equipment required
- Turbo System Tester Kit :VAG1687
- Ultrasonic Measuring Device :VAG1842
Procedure
Depending on the model, preliminary work may be required. Refer to CHARGE AIR SYSTEM, CHECKING FOR LEAKS .
Prepare the :VAG1687 as follows:
-- Completely remove the pressure regulating valve -2- and close the valves -3 and 4-.
- The knob must face upward so the pressure regulating valve can be turned.
-- Connect the :VAG1687 to the compressed air -1- with a commercially available intermediate piece.
-- Drain the water in the viewing glass via the water drain plug -6-.
-- Open the valve -3-.
Risk of damaging the components if the pressure is set too high.
- Never set the test pressure above the specified adjustment.
-- Set the pressure to 0.2 bar (2.9 psi) using the pressure control valve -2-.
-- Open the valve -4- and wait until the test circuit is filled. Regulate the pressure to 0.2 bar (2.9 psi) again if necessary.
-- Listen, feel and use commercially available leak detection spray or the :VAG1842 to check the charge air system for leaks. Refer to the Owner's Manual.
TIP:
A small quantity of air dissipates via the valves in the engine. For this reason a pressure retention test is not possible.
-- Release the pressure in the test circuit by removing the hose coupling before removing the adapter.
Assembling
Assemble in the reverse order of removal. Note the following:
- Replace the seal and O-ring after removal.
- Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
Additional procedures depending on the model: CHARGE AIR SYSTEM, CHECKING FOR LEAKS .