Turbocharger, Removing And Installing, Cylinder Bank 1 (Right): Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2023 Audi SQ8, 2023 Audi RS Q8, 2022 Audi SQ8, 2022 Audi RS Q8, and 2021 Audi SQ8. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Remove the reinforcement brace. Refer to OVERVIEW - LOCK CARRIER .
-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .
-- Remove the ribbed belt tensioner for the A/C compressor. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .
-- Loosen the hose clamp -1- and remove the coolant hose.
-- Remove the connector -arrow- for the Oxygen Sensor 1 Before Catalytic Converter -GX10- from the bracket, disconnect it and free up the wire.
All additional procedures are described under: TURBOCHARGER, REMOVING AND INSTALLING .