Charge Air Pressure Sensor 2 -G447-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2023 Audi SQ8, 2023 Audi RS Q8, 2022 Audi SQ8, 2022 Audi RS Q8, and 2021 Audi SQ8. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Remove the front left wheel spoiler. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .
-- Remove the lower left longitudinal member. Refer to OVERVIEW - LOCK CARRIER .
-- Loosen the hose clamps -arrows- on the left and right sides and remove air duct hose -1- (example image).
-- Disconnect the connector -1-.
-- Remove the bolt -2- and the Charge Air Pressure Sensor 2 -G447- (example image).