Overview - Ignition System
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2023 Audi SQ8, 2023 Audi RS Q8, 2022 Audi SQ8, 2022 Audi RS Q8, and 2021 Audi SQ8. However, it is still accessible from the selected car via links, so may be relevant.
- O-Ring
- Replace if damaged or leaking
- Camshaft Position Sensor 3 -G300-
- Exhaust side
- Removing and Installing. Refer to CAMSHAFT POSITION SENSOR, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Bolt
- 23 Nm
- Tightening specifications affect the function of the knock sensor
- Knock Sensor 1 -G61-
- Removing and Installing. Refer to Knock Sensor 1 -G61-, REMOVING AND INSTALLING .
- Bolt
- 23 Nm
- Tightening specifications affect the function of the knock sensor
- Knock Sensor 2 -G66-
- Removing and Installing. Refer to Knock Sensor 1 -G61-, REMOVING AND INSTALLING .
- O-Ring
- Replace if damaged or leaking
- Camshaft Position Sensor -G40-
- Intake side
- Removing and Installing. Refer to CAMSHAFT POSITION SENSOR, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Spark Plug
- Replacement interval. Refer to the appropriate Maintenance Tables.
- Tightening specification. Refer to SPARK PLUGS, REPLACING
- Spark Plug Connectors
- Installation position. Refer to IGNITION COILS, REMOVING AND INSTALLING .
- Ignition Coil
- Ignition Coil 1 with Power Output Stage -N70-
- Ignition Coil 2 with Power Output Stage -N127-
- Ignition Coil 3 with Power Output Stage -N291-
- Ignition Coil 4 with Power Output Stage -N292-
- Ignition Coil 5 with Power Output Stage -N323-
- Ignition Coil 6 with Power Output Stage -N324-
- Ignition Coil 7 -N325-
- Ignition Coil 8 -N326-
- Removing and Installing. Refer to IGNITION COILS, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-Ring
- Replace if damaged or leaking
- O-Ring
- Replace if damaged or leaking
- Engine Speed Sensor -G28-
- Removing and Installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- After replacing perform the listed adaptation in the 0001 - Engine Electronics Functions "0001 - Steps after replacing components" using the Vehicle Diagnostic Tester.
- Bolt
- 9 Nm
- O-Ring
- Replace if damaged or leaking
- Camshaft Position Sensor 2 -G163-
- Intake side
- Removing and Installing. Refer to CAMSHAFT POSITION SENSOR, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Knock Sensor 4 -G199-
- Removing and Installing. Refer to Knock Sensor 1 -G61-, REMOVING AND INSTALLING .
- Bolt
- 23 Nm
- Tightening specifications affect the function of the knock sensor
- Bolt
- 23 Nm
- Tightening specifications affect the function of the knock sensor
- Knock Sensor 3 -G198-
- Bolt
- 9 Nm
- Camshaft Position Sensor 4 -G301-
- Exhaust side
- Removing and Installing. Refer to CAMSHAFT POSITION SENSOR, REMOVING AND INSTALLING .
- O-Ring
- Replace if damaged or leaking