Vibration Damper, Removing And Installing, 3.0L Engine: Installing
WARNING: This page is about a different car, the 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
- Replace bolts that were tightened with an additional turn after removing them.
-- Position the vibration damper -1- on the crankshaft -2- and secure it with a new bolt. Pay attention to the alignment sleeve -arrow- at the same time.
-- Place the Adapter:T40330/4 with Counterholder:T40330/1 on the vibration damper and secure using the bolt -arrow- (23 Nm) to do so place the Spacer Sleeve:T40330/3 underneath.
-- Tighten the vibration damper bolt -1-.
-- Remove the bolt -arrow- and remove the counterholder.
-- Install the ribbed belt tensioner for the A/C compressor. Refer to RIBBED BELT TENSIONER FOR A/C COMPRESSOR, REMOVING AND INSTALLING, 3.0L ENGINE .
There are different procedures depending on the model. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .