Vibration Damper, Removing And Installing, 2.9L Engine: Removing
WARNING: This page is about a different car, the 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.
Depending on the model, preliminary work may be required. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
-- Remove the generator ribbed belt. Refer to RIBBED BELT FOR GENERATOR, REMOVING AND INSTALLING, 2.9L ENGINE .
-- Remove the ribbed belt tensioner for the A/C compressor. Refer to RIBBED BELT TENSIONER FOR A/C COMPRESSOR, REMOVING AND INSTALLING, 2.9L ENGINE .
-- If still installed, remove the cover, remove the bolt -arrow- and the idler roller.
-- Place the Adapter:T40330/4 with Counterholder:T40330/1 on the vibration damper and secure using the bolt -arrow- (23 Nm); to do so, place the Spacer Sleeve:T40330/7 underneath.
-- Remove the bolt -1-.
-- Remove the bolt -arrow- and remove the counterholder and vibration damper.