Crankshaft, Removing And Installing: Notes

WARNING: This page is about a different car, the 2023 Audi Q8. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Puller - Unit Injector:T10055

Fig 1: Puller - Unit Injector
Courtesy of AUDI
Screwdriver:T10248 , not illustrated
Locking Pin (3 pc.):T40011

Fig 2: Identifying Locking Pin T40011
Courtesy of AUDI
Extracting Tool :T40332

Courtesy of AUDI
Locking Tool:T40362 , not illustrated

Prepare the Extracting Tool :T40332

Fig 3: Puller

Courtesy of AUDI

-- Tighten the pull rod -1- with the bolts -arrows- as shown on the puller cross bar Extracting Tool: T40332 .

-- Remove the threaded pins -2- for later assembly of the tool.