Drive Plate, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi Q7 and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission removed. Refer to the appropriate Service Information. .
-- Insert the Counterhold - Flywheel:10 - 201 to loosen the bolts.
CAUTION:
Risk of damaging the outer surface of the bearing flange at the drive plate if using unsuitable tools.
- Use an internal multi-point socket with a shaft that is at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts and remove the drive plate -1-.