Charge Air Pressure Sensor 2 -G447-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi SQ7 and 2023 Audi SQ7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Remove the front left wheel spoiler. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .
-- Remove the lower left longitudinal member. Refer to OVERVIEW - LOCK CARRIER .
-- Loosen the hose clamps -arrows- on the left and right sides and remove air duct hose -1- (example image).
-- Disconnect the connector -1-.
-- Remove the bolt -2- and the Charge Air Pressure Sensor 2 -G447- (example image).