Cylinder Bank 1 (Right) Camshaft Housing, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi Q7 and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the right coolant pipe from the longitudinal member. Refer to RIGHT COOLANT PIPES ON LONGITUDINAL MEMBER, REMOVING AND INSTALLING .
-- Loosen the hose clamp -1- and disconnect the hose for the EVAP system.
-- Close open lines and connections with clean plugs from the Engine Bung Set:VAS6122 .
All other procedures are described. Refer to CAMSHAFT HOUSING, REMOVING AND INSTALLING .