LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2021 >> S5 Premium Plus, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 279 (Crankshaft, Cylinder Block (6-Cylinder Direct Injection 3.0L 4V TFSI Engine Ea839)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Vibration Damper, Removing And Installing >> Removing

Vibration Damper, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi SQ5 and 2023 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the lock carrier cover, right and left air intake grille as well as the bumper cover end plate. Refer to Front Bumper .

-- Remove the front noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove the left and right front wheel spoiler. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Remove the left front lower longitudinal member. Refer to Lock Carrier ; Lower Longitudinal Member, Removing and Installing.

-- Loosen the hose clamp -arrow- and remove the air duct hose from the air duct pipe.

GWWA21-11182Courtesy of AUDI

-- Remove the left and right bolt -1- and push the coolant pipe on the lock carrier toward the rear.

Fig 1: Coolant Pipes on Lock Carrier
GWWA19-12676Courtesy of AUDI

-- Loosen the hose clamp -1- and remove the front left air duct pipe from the charge air cooler.

GWWA21-11082Courtesy of AUDI
NOTE:

Ignore -arrows-

-- Place the container of the :VAS5014  or :VAS6208  underneath.

Fig 2: Engine Coolant Temperature Sensor on Radiator Outlet -G83- Component Location
GWWA19-12677Courtesy of AUDI

-- Disconnect the connector -1- for the Engine Coolant Temperature Sensor on Radiator Outlet -G83-.

-- Lift the clamp -3- and remove the lower right coolant hose from the radiator and drain the coolant.

-- Remove the bolts -arrows- and air duct -1-.

GWWA23-11115Courtesy of AUDI

-- Release the left and right catches in direction of -arrows- and remove the retaining pin -1- for the radiator upward.

GWWA19-12319Courtesy of AUDI

-- Cut through the air duct -1- in the area of the pass-through for the refrigerant lines using diagonal pliers -arrows-.

GWWA10-12162Courtesy of AUDI

-- Release the catches -arrow- and remove the air ducts -1 and 3-.

GWWA21-11081Courtesy of AUDI

-- Secure the upper radiator again using the retaining pins.

-- Release the catches -arrows- and remove the air duct -1-.

GWWA19-12653Courtesy of AUDI

-- Remove the left and right bolt -2- and push the radiator bracket -1- with the bolt toward the front in direction of -arrow-.

GWWA19-12654Courtesy of AUDI

Additional procedures. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .