Valve Stem Seals, Removing And Installing, Cylinder Head Installed: Removing

-- Remove the camshafts. Refer to CAMSHAFT, REMOVING AND INSTALLING .

-- Cylinder 1 intake side: remove the bolts -arrows- and also remove the engine lifting eye -1-.

Courtesy of AUDI

-- Remove the spark plugs using the Spark Plug Removal Tool:3122B  .

Courtesy of AUDI

-- Set the piston for the respective cylinder to "bottom dead center (BDC)", to do so, turn the crankshaft at the hex fitting of the Vibration Damper Assembly Tool - Turning Over Tool:T10531/3  .

Fig 1: Identifying Assembly Tool - Turning Over Tool T10531/3

Courtesy of AUDI

-- Align the Valve Keeper Tool Kit - Guide Plate:VAS5161/44  on the cylinder head at the same time pay attention to the marking:

Courtesy of AUDI

A -  Exhaust Valves

E -  Intake Valves

-- Secure the guide plate with the Valve Cotter Tool Kit - Knurled Thumb Screws:VAS5161/12  .

-- Position the Valve Cotter Tool Kit - Punch:VAS5161/3A  on the valve spring and loosen the stuck valve retainers with a plastic mallet.

-- Install the Valve Cotter Tool Kit - Adapter:T40012  in the spark plug threads.

-- Connect the adapter to the compressed air using a commercially available intermediate piece and give steady pressure.

• Minimum pressure: 6 bar (87.02 psi)

-- Install the Valve Cotter Tool Kit - Retainer:VAS5161/6  with the Guide Forks M6/M8 with Valve Cotter Tool Kit - Threaded Studs:VAS5161/5  in the guide plate.

Fig 2: Identifying Valve Cotter Tool Kit - Guide Plate 19c VAS5161/19C

Courtesy of AUDI

-- Push the Valve Cotter Tool Kit - Assembly Cartridge:VAS5161/8A  into the guide plate.

-- Engage the Valve Keeper Tool Kit - Pressure Fork:VAS5161/2  at the engaging device and press the installation cartridge downward.

-- At the same time, turn the installation cartridge knurled bolt right until points engage in the valve retainers.

-- Move the knurled bolt left and right slightly. This presses the valve retainers apart and captures them in the assembly cartridge.

-- Release the pressure fork.

-- Remove the assembly cartridge.

-- Remove the guide plate and turn it aside.

• The pressurized air hose remains connected.

-- Remove the valve spring and the valve spring retainer.

-- Remove the valve stem seal using the Puller - Valve Seal:3364  .

Fig 3: Identifying Valve Seal Removal Tool 3364

Courtesy of AUDI