Charge Air Pressure Control Module -GX34-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi Q5 e, and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
TIP:
The following step is only required, if the bolts must be replaced.
-- Remove the bolts -arrows- and remove the heat shield -1-.
-- Slightly lift the locking spring -3- with a small screwdriver and remove from the ball pin control rod.
-- Disconnect the connector -2-.
-- Remove the bolts -arrows- and the Charge Air Pressure Control Module -GX34-.