Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi Q5 e, and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Audi A4/A5:

Courtesy of AUDI

-- Loosen the screw-type clamp -2-, remove the air duct pipe from the Throttle Valve Control Module -GX3- and slightly push it to the left side.

Charge Air Pressure Sensor -G31- with Threaded Connection:

Courtesy of AUDI

-- Disconnect the connector -1-.

-- Remove the bolt -2- and disconnect the connector -1- and remove it from the air duct pipe.

Charge Air Pressure Sensor -G31- with Locking Tab:

Courtesy of AUDI

-- Disconnect the connector -1-.

-- Turn the Charge Air Pressure Sensor -G31- -2- clockwise and remove from the air duct pipe.