Overview - Radiator/Radiator Fan
WARNING: This page is about a different car, the 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi Q5 e, and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Radiator
- Removing and Installing. Refer to RADIATOR, REMOVING AND INSTALLING .
- After replacing, replace entire amount of coolant
- Plug
- Not available separately.
- Do not open
- O-Ring
- Not available separately.
- Coolant Hose
- Lift the clamp to remove
- Connecting. Refer to Fig 2.
- O-Rings
- Replace if damaged or leaking
- Coat with coolant
- Coolant Hose
- Lift the clamp to remove
- Connecting. Refer to Fig 2.
- Coolant Ventilation Line
- To the coolant expansion tank
- Lift the clamp to remove
- Connecting. Refer to Fig 2.
- O-Ring
- Replace if damaged or leaking
- Coat with coolant
- Rubber Bushing
- For the radiator
- Sleeve
- Retaining Pin
- Disengage and remove using the screwdriver
- Air Duct
- Rubber Bushing
- For the radiator
- Radiator Bracket
- Bolt
- 5 Nm
- Backing Plate
- Bolt
- 4.5 Nm
Connect the Coolant Hose to the Connector Coupling
-- Replace the damaged clamp -3-.
-- Check the O-ring -2- or Y-ring -5- for damage. The O-ring can optionally be replaced by the Y-ring. When installing the Y-ring, mind the installation position, the groove points towards the inside.
-- Coat the O-ring or Y-ring with coolant on the new component.
-- Press the coolant hose on to the coolant pipe -1- until it engages audibly.
-- Press the coolant hose on again and pull to make sure the connector coupling is engaged correctly.