Coolant Pump, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi Q5 e, and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Controller Housing

Courtesy of AUDI

Install in the reverse order of removal while noting the following:

-- Position the toothed belt and bring the coolant pump -1- into installation position.

-- Pay attention that the centering piece -arrows- and seal -3- are seated correctly.

-- Tighten the coolant pump bolts. Refer to Figure.

-- After installing a new coolant pump -2-, remove the protective cap -1- from the drive wheel.

Fig 2: Identifying Coolant Pump

Courtesy of AUDI

Used coolant cannot be used again.

-- Fill the coolant. Refer to COOLANT, FILLING USING Cooling System Charge Kit:VAS6096 [DMSA, DMSB] .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .