Coolant Pump Toothed Belt, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi Q5 e, and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Replace bolts that were tightened with an additional turn after removing them.
- Note the toothed belt sprocket installation location -item 12- OVERVIEW - COOLANT PUMP/COOLANT THERMOSTAT.
- Used coolant cannot be used again.
-- Install the Oil Pressure Switch, Level 3 -F447-. Refer to Oil Pressure Switch, Level 3 -F447-, REMOVING AND INSTALLING .
-- Connect the coolant hose to the connector coupling. Refer to Figure.
-- Fill with coolant. Refer to COOLANT, FILLING USING Cooling System Charge Kit:VAS6096 [DMSA, DMSB] .
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .