Oil Separator, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi Q5 e, and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the cylinder ignition coils "3 and 4". Refer to IGNITION COILS, REMOVING AND INSTALLING .
-- Remove the bolts -arrows- and move the engine lifting eye -1- to the side.
-- If installed, disconnect the connector -1- for the Tank Ventilation Pressure Sensor 1 -G950-.
-- Loosen the hose clamp -1- and remove the hose from the EVAP Canister Purge Regulator Valve 1 -N80-.
-- Press the release buttons on both sides and remove the crankcase ventilation hose -2-.
-- Remove the bolts -arrows- and the oil separator.