Needle Bearing In Drive Plate, Replacing

WARNING: This page is about a different car, the 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi Q5 e, and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Press Piece - 31.5mm:VW418A

Fig 1: Identifying Press Piece
Courtesy of AUDI
Press Piece - 28x100mm:VW421

Fig 2: Identifying Tube 28 mm Dia. 100 mm VW 421
Courtesy of AUDI
Bearing Installer - Multiple Use:40-103

Fig 3: Bearing Installer - Multiple Use 40-103
Courtesy of AUDI
Pneumatic hydraulic press, for example :VAS6654 , not illustrated

Only available with the manual transmission a needle bearing is installed in the drive plate.

Procedure

Fig 4: Identifying Drive Plate, Removal

Courtesy of AUDI

The transmission is removed. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .

-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Place the Bearing Installer - Multiple Use:40 - 103 under the drive plate to remove and install.

-- Press out the needle bearing using the Press Piece - 28x100mm:VW421 and workshop press.

The thinner diameter of the Press Piece - 28x100mm Press Piece - 28x100mm:VW421 points towards the drive plate.

-- Carefully press the needle bearing in all the way using the Press Piece - 31.5mm:VW418A and workshop press.

Fig 5: Identifying Drive Plate, Removal

Courtesy of AUDI

Installation position: the closed side of the needle bearing faces the engine.

-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .