Ribbed Belt For Generator, Removing And Installing, 2.9L Engine: Installing

WARNING: This page is about a different car, the 2024 Audi SQ5 and 2023 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Install the ribbed belt. Refer to Figure.

-- Pivot the ribbed belt tensioner for the generator using a wrench slightly counter-clockwise -arrow- and remove the Locking Pin:T10060A .

-- To tension the ribbed belt release the tensioner.

-- Check whether the ribbed belt is routed correctly.

-- Install the A/C compressor ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Start the engine and check the ribbed belt routing.

There are different procedures depending on the model. Refer to RIBBED BELT, REMOVING AND INSTALLING .