Overview - Lock Carrier
WARNING: This page is about a different car, the 2022 Audi S4 and 2022 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Overview - Adjusting Element. Refer to the appropriate Service Information .
- Bumper Carrier
- Overview. Refer to OVERVIEW - BUMPER CARRIER .
- Air Duct
- Clipped into the bumper cover bracket
- Bolt
- 8 Nm
- Lower Air Guide
- For the radiator
- Bumper Cover Bracket
- Removing and Installing. Refer to BUMPER COVER BRACKET, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to OVERVIEW - AIR FILTER HOUSING - 2.0L (DMSA) , OVERVIEW - AIR FILTER HOUSING - 2.0L (DPAA) or OVERVIEW - AIR FILTER HOUSING - 3.0L .
- Air Duct
- For the air filter housing
- Clean off any salt and dirt
- Upper Air Duct
- For the radiator
- Lock Carrier
- Removing and Installing. Refer to LOCK CARRIER, REMOVING AND INSTALLING .
- Bolt
- 10 Nm
- Bolt
- Quantity: 2
- 14 Nm
- Mount
- For bumper carrier
- Bolt
- Tightening specification -item : Bolt .
- Bolt
- 5 Nm
- Pop Rivet
- Quantity: 2
- Spring Element
- For the bumper cover bracket
- Removing and Installing. Refer to SPRING ELEMENT FOR BUMPER COVER BRACKET, REMOVING AND INSTALLING .
- Adjusting. Refer to HEIGHT, ADJUSTING USING SPRING ELEMENT .
Spring element for bumper cover bracket, market-specific version
- Bumper Carrier
- Pop Rivet: Quantity 2
- Support with support for bumper cover bracket. Refer to SPRING ELEMENT FOR BUMPER COVER BRACKET, REMOVING AND INSTALLING for removing and installing and Refer to HEIGHT, ADJUSTING USING SPRING ELEMENT for adjusting.
Retaining pin for front noise insulation, A5 cabriolet
- Lock Carrier
- Bolt: 8 Nm
- Retaining Brace
- Screw: 4.5 Nm