Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING, BOLTED VERSIONS: Removing
WARNING: This page is about a different car, the 2021 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Loosen the screw-type clamp -2-, remove the air duct pipe from the Throttle Valve Control Module -GX3- and slightly push it to the left side.
-- Seal off any open lines and connections with plugs that are thoroughly cleaned from the : VAS6122 .
-- Disconnect the connector -1-.
-- Remove the bolt -2- and remove the Charge Air Pressure Sensor -G31- from the air duct pipe.