Engine, Securing To Engine And Transmission Holder

WARNING: This page is about a different car, the 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi Q5 e, and 2023 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine and Gearbox Bracket:VAS6095A

Fig 1: Engine And Transmission Holder
Courtesy of AUDI

Procedure

Engine engaged with the Engine Sling:2024A on the Shop Crane:VAS6100 . Refer to ENGINE, REMOVING FROM SCISSOR LIFT TABLE .

-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Remove the intermediate plate. Refer to Fig 2.

Fig 2: Installing Intermediate Plate

Courtesy of AUDI

-- Remove the left alignment sleeve from the cylinder block.

-- Secure the engine as shown to the Engine and Gearbox Bracket:VAS6095A -1-.

Courtesy of AUDI

Assembling

Assemble in the reverse order of removal. Note the following:

-- Insert the alignment sleeve into the cylinder block.

-- Install the intermediate plate. Refer to Fig 2.

Fig 3: Installing Intermediate Plate

Courtesy of AUDI

-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .