Perform Adaptations After Component Replacement
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
Adapting the Adaptation Values after Replacing Components
An adaptation of the adaptation values is required after the following procedures:
- The engine was replaced.
- The sensor wheel for the Engine Speed Sensor -G28- was replaced.
- The components of the chain drive were removed and installed or replaced.
- The cylinder head was removed and installed or replaced.
- The camshafts were removed and installed or replaced.
- The Engine Temperature Control Actuator -N493- has been replaced
- The Radiator Shutter Motor -V544- was replaced.
- The Throttle Valve Control Module -GX3- were replaced.
- The particulate filter was replaced.
-- Connect the Vehicle Diagnostic Tester.
-- Switch on the ignition and select Guided Functions use the Vehicle Diagnostic Tester.
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
Procedure Version 1:
- Drivetrain
- Select the engine code and engine
- 0001 - OBD-capable systems
- 0001 - Engine Electronics
- 0001 - Engine electronics, functions
After replacing the engine/motor control module:
- 0001 - Replacing the Engine/Motor Control Module
After replacing the charge air pressure actuator:
- 0001 - Charge Air Pressure Actuator -V465 adjusting
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
Procedure Version 2:
- Diagnostic-capable systems
- 0001 - Engine electronics J623
- 0001 - Engine electronics, functions
- 0001 - Step after replacing components
After replacing the engine/motor control module:
- 0001 - Replacing the Engine/Motor Control Module
After replacing the charge air pressure actuator:
- 0001 - Charge Air Pressure Actuator -V465 adjusting
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.