Wheel Bearing Unit, Removing And Installing, Fwd: Installing

Fig 1: Front Seal And Grease Stub Axle

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal and note the following:

• Replace the cap after removing.

-- Clean the front seal.

-- Install the front seal and grease the axle stub -arrow- lightly with Grease.

-- Install the brake caliper and the brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .

Fig 2: Dust Cap

Courtesy of AUDI OF AMERICA, LLC

-- Drive in the new cap all the way using the Camshaft Installer Kit - Sleeve : 3241/4  -1-.

-- Install the brake shield. Refer to BRAKE SHIELD, REMOVING AND INSTALLING .