Wheel Bearing Housing, Removing And Installing: Installing

Install in reverse order of removal and note the following:

-- Install the threaded connections up to the stop but do not tighten yet.

• Bonded rubber bushings have a limited range of rotation. Only tighten the threaded connections for the suspension when the vehicle is at standard vehicle height.

-- Raise the wheel bearing to the standard vehicle height. Refer to WHEEL BEARING AT STANDARD VEHICLE HEIGHT, LIFTING VEHICLES WITH AIR SUSPENSION .

-- Install the brake shield. Refer to BRAKE SHIELD, REMOVING AND INSTALLING .

-- Tighten the threaded connection between the drive axle and wheel hub. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .

• Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .