Impact Member, Removing And Installing, Equipment Versions Without Trailer Hitch: Installing
Install in reverse order of removal and note the following:
- The impact member must be at room temperature.
- The adhesive surface must be free of dirt and grease.
-- Remove adhesive residue from the body.
-- Clean the adhesive surface using the Cleaning Solution:D 009 401 04 .
-- Remove the protective film from the adhesive tape and tape the foam seal on the impact member according to the dimensions.
- Dimension -a- = 49.6 ± 2 mm
- Dimension -b- = 12.9 ± 2 mm
- Dimension -c- = 2.1 ± 2 mm
- Dimension -d- = 0 ± 2 mm
- Impact member resting time is at least 30 minutes at room temperature.