Active Steering Control Module -J792-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi S5, 2022 Audi A5 Quattro, 2021 Audi S5, 2021 Audi A5 Quattro, and 2020 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Activate the control module after installing a new Active Steering Control Module -J792-.
-- Connect the Vehicle Diagnostic Tester.
-- Switch the ignition on.
-- Select and start the Diagnostic operating mode.
-- Select the Test plan tab.
-- Select the Select individual test button and select the following tree structure consecutively:
- Chassis
- Suspension control
- 0001 - OBD-capable system
- 001B - Active Steering Control Module J792
- 001B - Active Steering Control Module functions J792
- 001B - Replace control module
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- The basic setting must be performed if the Active Steering Control Module -J792- was replaced. Refer to DYNAMIC STEERING BASIC SETTING .